The Pure Mist coil master pro Full Kit Edition Is easily the most revolutionary, ultra functionary auto coiler on the market it will create tight, uniform coils in just seconds. Build from 20 – 28 Gauge rounded kanthal wire or any low resistant wires with just twist of your finger!The Pure Mist coild master pro makes coiling a breeze. Simply trap your wire, rotate the top cap, and you get that perfect micro coil in seconds, each and every time!Light weight and portable, perfect for travel, and on the go! Unique styling with stylish colors, each color represent each coil size – Make 1mm coils 1.5mm coils 2 mm coils, 2.5mm coils 3mm Coils 3.5mm coils Directions: Insert the socket screw into the appropriate hole of the winder sectiona. For 26 – 28 gauge wire, use hole number 1b. For 20 – 24 gauge wire, use hole number 2insert wire through hole on the side of the handle.# Leave about 1/2″ of the wire protruding from the hole. Hold the end of the wire against the handle so it won’t pull through Pull the loose end of the wire around the shaft Slide the winder section over the shaft with the pin facing toward the handle Turn the winder section so that it catches the wire and starts wrapping it around the shaft. Keep light pressure against handle while winding. Excessive pressure will force smaller gauge wire to wrap over itselfWhen finished, remove winder and straighten the wire end that protrudes from the hole in the handlePush up on the wire to slide coil up. Carefully grab the coil at the bottom to slide it off the shaft Note: The coiler winds the coils with the loops touching each other. This can initially give wrong resistance values without first burning in the coil.